Here is the importing guide. @hevans
If you run into any problems or have any questions let me know.

 Not sure what format you are looking for? Historical raw data or DCP?
But here is our raw Sutron file KiDAT task for our historical data. I attached an example of what our raw text file looks like.

If you have any questions or problems let me know. 

Not sure if this will work for them but I've used AT commands in the past for this.

For speaker loudness:
AT+L<value>       : <value> = 0 Low speaker volume
                                             1 Low speaker volume
                                             2 Medium speaker volume
                                             3 High speaker volume
           or

To set speaker mode to mute:
AT+M<value>      : <value> = 0 Speaker is off
                                             1 Speaker is on   

Hello,

Just wanted to share some of our Lake Level gauge setups with everyone. We've been working on these setups for quite some time and tweak it at every site we do. We currently have 15 Lake level sites and they seem to be functioning quite well with WISKI. Photos of some of the gauges are attached. Let me know if you have any questions.

Equipment;
Loggers - Sutron 8210 /8310 / Sutron GPRS Link 
Telemetry- Microhard Bullet 4G/LTE non-GPS modem
Power- Solar panel – 50 W  with Battery - 35 amp/hr
Sensors - INW  PT12 Submersible Pressure Transducer / Son Tek Argonaut-SW / OTT-RLS Radar

 The problem I found was the task didn't like it when there were seconds recorded in the timestamp. I ended up just opening up the .lev files in notebook and used the replace tool. I just typed replace - :01.0   with - :00.0 and it seems to work and gets rid of those pesky seconds recorded! Then I just save that file and throw it into KiDAT.

Hey,

Here's the snow survey KiDAT task. I also have a how to guide for importing the data for anyone who wants it!

FYI! I figured it out. Range related editing -stretch vertically does the job.

Has anybody shifted a decimal point in a data set before? If so, where do you do the calculation?

09/03/2008   05:00:00 AM   439.30000
09/03/2008   06:00:00 AM   438.80000
09/03/2008   07:00:00 AM   438.10000
09/03/2008   08:00:00 AM   438.00000
09/03/2008   09:00:00 AM   437.90000
09/03/2008   10:00:00 AM   437.90000
09/03/2008   12:00:00 PM   0.43970
09/03/2008   01:00:00 PM   0.43890
09/03/2008   02:00:00 PM   0.43770
09/03/2008   03:00:00 PM   0.43650
09/03/2008   04:00:00 PM   0.43600
09/03/2008   05:00:00 PM   0.43490

Any news from Kisters on Field Visits status?

Lets see if the email notification works!